Features of retroreflectometer for road marking and light adjustment method

Retroreflectometer for road marking can be used to measure various retroreflective devices on the road. Why not choose other devices for measurement instead of this one? Here is a look at what features the device has when it is used. This article also includes the method of adjusting the light of the retroreflectometer for road marking.

Here is the content list:

Features

Light adjustment

Features

The retroreflectometer for road marking can be used during the day or in the dark, so there is no restriction on the time of use, and it can be used for measurement throughout the day.

Because the operation of the retroreflectometer for road marking itself is relatively simple, there is no confusion when operating it, and the value of the retroreflectometer for road marking can be expressed in intuitive numbers.

The retroreflectometer for road marking is generally equipped with a special set of standards, so in the use of the direct use of data transfer mode of memory, so compared to other measuring tools car to measure out the accuracy is relatively high.

Retroreflectometer for road marking in the measurement is in full compliance with the relevant national road measurement standards, and after the measurement out of the data can also be stored for query and other operations, and can also import the data into the computer above the display.

The size of the retroreflectometer for road marking itself is relatively small and easy to carry, and there is a rechargeable battery inside so that it is more convenient when using.

Light adjustment

Generally speaking, the light on the retroreflectometer for road marking has been adjusted to a more appropriate state before leaving the factory and has been fixed firmly using screws and pressure rings, so we must not loosen it ourselves when using it in general. When there is damage and do not know how to repair when you can return to the manufacturer for a repair if we can replace their own words can be replaced. But the retroreflectometer for road marking in the replacement of the light bulb at the same time also need to adjust the focal length to the right angle, this is also because after the replacement of the focal length and the previous may have a gap, so we need to adjust it to the same size as before.

In the replacement of the first need to be used to fix the screw-down, and then the retroreflectometer for road marking base off, take off the nut, and then in the bad light down to replace the good bulb, and then just reverse the steps again. After the replacement will need to adjust the focus position of some lights, the specific method of operation is to place a piece of white paper at a distance of 50 cm from the lens, in the adjustment time only need to move the lamp headpiece can adjust the focus, adjust the end of the screw will be tightened on the retroreflectometer for road marking can be used.

The above is a retroreflectometer for road marking features and adjust the light method. If you want to know more about retroreflectometer for road marking, you can contact Nanjing T-Bota Scietech Instruments & Equipment Co.